Electrical/Electronics Manufacturing Technician

Key Responsibilities

Assemble control panels, backplates, and enclosures following schematics, wiring diagrams, and layout drawings

Install and mount components such as breakers, relays, contactors, PLCs, power supplies, terminal blocks, and hardware

Route, cut, strip, crimp, and terminate wires according to wiring standards. Maintain clean and organized wiring paths and panel layouts

Label wires, components, and enclosures accurately

Soldering & PCB Assembly - Through-hole and surface-mount soldering, rework, and inspection to IPC standards.

Use hand tools, power tools, and torque tools safely and correctly

Wiring & Harness Fabrication - Building cable assemblies, connectors, DMX cabling, power harnesses, and fixture wiring.

Component Identification - Resistors, capacitors, ICs, LEDs, drivers, MOSFETs, microcontrollers, etc.

Firmware loading and basic microcontroller programming

Perform point-to-point wiring checks and continuity testing

Testing & Troubleshooting - Using multimeters, scopes, and test fixtures to verify electrical performance and to diagnose failures.

Document work performed and report issues or discrepancies to engineering or supervisors

Maintain a safe, clean, and efficient work environment

Ability to perform power-up testing

Required Skills & Qualifications

Experience in electrical assembly, wiring, or control panel building

Ability to read and interpret electrical schematics, wiring diagrams, and BOMs

Proficiency with wire crimping, terminating, and cable management

Familiarity with hand tools, power tools, and electrical test equipment

Ability to drill, tap, cut, and mount components on backplates or enclosures

Ability to perform continuity checks and point-to-point verification

Soldering experience (through hole or surface mount).

Experience with multimeters and basic electrical test equipment

Ability to perform power-up testing

Understanding of functional testing procedures and documentation

Strong attention to detail and craftsmanship

Ability to follow instructions and work independently or as part of a team

Physical Requirements

Ability to stand or sit for extended periods

Ability to lift up to 30 lbs as needed

Good manual dexterity and hand-eye coordination

Lehigh Electric Products jobs